FAQ-3D Printing

• What should I do if the first layer does not stick to the Print Sheet?
• What should I do if the 3D Printing Module pushes into the Print Sheet?
• What should I do if the Touchscreens keeps showing “Filament Runout”?
• What should I do if there is a blob on the nozzle?
• What should I do if the Touchscreen shows a -30℃ or or abnormally high nozzle temp？
• What should I do if the filament won't load?
• What should I do if the 3D Printing Module cannot be detected?
• What should I do if the Heated Bed won't heat up?
• What is the recommended 3D printing settings in Cura or Simplify3D for Snapmaker 2.0?
• What is the nozzle diameter?
• Can Snapmaker 2.0 print with nylon?
• What types of filaments can I use with Snapmaker 2.0?
• Does A350 support a higher Heated Bed temperature than 80℃?
• Can I print ABS with Snapmaker 2.0?
• What is the layer resolution of Snapmaker 2.0?
• Can I use Snapmaker 2.0 for jewelry model printing?
• Will you offer nozzles with various diameters?
• Can I achieve a higher Heated Bed temperature by using a third-party power module?