Read the Quick Start Guide to see what's in the box, machine assembly, and initial setup for first use. Video tutorials are also available on our YouTube channel.

1.1 Assembly Tips

To ensure better engraving or cutting results, you are recommended to check the following assembly steps:

① Align the Y axes with the grooves of the Base Plate of the machine

While attaching the two Y-axis Linear Modules to the Base Plate, make sure that the Y axes are accurately mounted onto the grooves of the Base Plate.

② Push the CNC Carving Platform to the leftmost or rightmost end

Slightly loosen all positioning screws on the CNC Carving Platform, not completely out of the nuts. Push the CNC Platform horizontally till the leftmost or rightmost end to keep its left edge parallel that of the Base Plate. Tighten the screws again.

③ Align the Base of the Rotary Module with the CNC Carving Platform

While attaching the Base to the middle of the CNC Carving Platform, make sure that the two vertical edges of the Base parallels the vertical lines drawn on the CNC platform.  

1.2 Software Setup

Download our software Snapmaker Luban (Luban hereafter), and update it to version 3.14.0 or above. This manual takes version 4.0.0 as a demonstration to generate the G-code file.

1.3 Firmware Setup

Update the firmware to version 1.12.0 or later via Wi-Fi or USB flash drive.

: Turn on the machine > Connect your machine to a Wi-Fi network > Swipe left on the Touchscreen > Tap Settings > Firmware Update > Check for Updates > Update Now > Complete.

: Download our firmware > Insert the USB flash drive into the Controller > Turn on the machine > Swipe left on the Touchscreen > Tap Files > USB > Tap the firmware file to update.