What should I do if the software goes blank after clicking the button of "Camera Capture"? Edwin May 06, 2020 11:54 Please upgrade the software Snapmaker Luban to 3.42 or later. https://forum.snapmaker.com/t/snapmaker-luban-downloads-and-updates/4949/11 Related articles What should I do if the laser beam stays at full power? What should I do if there are some black lines on the camera capture pictures? What should I do if the 3D print module cannot heat up? What should I do if the printing module stops at the final point after the print is completed? What should I do if camera capture feature always get stuck and the camera does not work? Comments 0 comments Please sign in to leave a comment.