How to replace the wires of the hot end kit? Edwin April 28, 2020 11:23 Please refer to this link to learn about how to replace the wires of the hot end kit if it is defective. https://drive.google.com/open?id=1XGdGKD_YUZniNiOzPjHzk8qyui725Z4G Related articles How to replace the nozzle for Snapmaker 2.0? How to adjust the probe/proximity sensor in the 3D printing module? What should I do if there is a vibration noise when the machine is printing? What should I do if the touchscreen does not boot up? What should I do if the printing module calibrates or prints in the air? Comments 0 comments Please sign in to leave a comment.