Skip to main content
Can I use Nylon to for 3DP working?
Was this article helpful?
3 out of 6 found this helpful
Return to top

Comments

1 comment

  • Gunnar Faith-Ell

    Nylon works well on snapmaker 2.0 but it wont stick to the board. I got the best result by using painters blue tape on the board and recalibrate the printer to include the thickness of the blue tape; put a pice of blue tape on a paper and use it for the final calibration. Then put blue tape on the area where the part will be printed. The blue tape can be reused for several prints and is easy to remove.

    • Bed temperature 65C
    • Print temperature 265C
    • Print head fan off (command M107)
    • An increase of the infill could be done to improve the print result.

     

    0

Please sign in to leave a comment.